Do not touch, unless you know what you are doing. This property is here mainly for maintaining backward compatibility. Face Maker Class: sets C++ class name of face making code, which is used when making solids from wires.Taper does not work well if the shape contains B-splines. version 0.19 and below Tapered extrusion is only supported for shapes without inner structures.This is done to facilitate the design of molds and molded parts. introduced in version 0.20 Inner structures receive the opposite taper angle.Taper Angle Rev sets the taper for the reversed part of the extrusion (the part from Length Rev). Positive angle means the cross-section expands. Taper Angle and Taper Angle Rev: applies an angle to the extrusion, so that sides of the extrusion are drafted by the specified angle.Symmetric: if True, extrusion is centered at the input shape, and total length is Length Fwd.Reversed: reverses the extrusion to go against Dir.Solid: if True, extruding a closed edge or a closed wire will yield a solid.Length Rev: Additional length to extrude against Dir.If both Length Fwd and Length Rev are zero, the length of Dir vector is used. Length Fwd: The distance to extrude by.'Normal' means Dir is perpendicular to the plane of the input shape. 'Edge' means Dir is obtained from an edge (line) linked by Dir Link. Dir Link: parametric link to an edge (line) that sets the direction of extrusion. Otherwise, Dir is read-only, and computed from the linked shape. If Dir Mode is 'Custom', you can edit Dir.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |